Antares ATR-1a - Manual (Page 44)

44
MIDI System Exclusive Message Formats
In the explanations, below, braces < > are used to represent enclosed MIDI
data bytes. Concatenated data is shown by < > < >. Names are also enclosed
in braces as symbolic representations defined further into the explanation.
Values are decimal unless an H is used to denote Hexadecimal values.
For example, the MIDI bytes to select song mode for DEVICE NUMBER 3 are:
F0H, 0, 1, 26H, 3, 1, F7H.
=
= <0 1 26H>
= one byte in range 0 to 15. Must match
SYSEX DEVICE NUMBER set in the ATR-1a.
= <0> to select program mode.
or <1> to select song mode.
or <2> bypass on
or <3> bypass off
or <4><14>
or <5><31>
or <6><34>
=
1 to 16, 0 = OMNI
controller 0 = off, 1 = on
controller 0 = off, 1 = on
controller 0 = off, 1 = on
controller 0 = off, 1 = on
controller 0 = off, 1 = on
0 = BYPASS, 1 = STEP
14 to 31, 13 = OFF
14 to 31, 13 = OFF
14 to 31, 13 = OFF
0 = off, 1 = on
1 to 25
0 to 100
0 = make sharp, 1 = make flat
=
1 to 50
0 to 25
… for C, C#,…: 0=remove, 1 =tune, 2=bypass.
0 = off, 1 = SINE, 2 = SQUARE, 3 = SAW
0 to 100 cents
1 to 97 (.1 to 9.7 sec)