Asus External Slim Combo Drive SCB-2424A-U - Manual (Page 4)

4 4 4 4 4 A S U S S C B - 2 4 2 4 A - U e x t e r n a l s l i m c o m b o d r i v e A S U S S C B - 2 4 2 4 A - U e x t e r n a l s l i m c o m b o d r i v e A S U S S C B - 2 4 2 4 A - U e x t e r n a l s l i m c o m b o d r i v e A S U S S C B - 2 4 2 4 A - U e x t e r n a l s l i m c o m b o d r i v e A S U S S C B - 2 4 2 4 A - U e x t e r n a l s l i m c o m b o d r i v e
Notices
Federal Communications Commission Statement Federal Communications Commission Statement Federal Communications Commission Statement Federal Communications Commission Statement Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules . Operation is subject to
the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
manufacturer’s instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
W A R N I N G ! W A R N I N G ! W A R N I N G ! W A R N I N G ! W A R N I N G ! The use of shielded cables for connection of the monitor to
the graphics card is required to assure compliance with FCC regulations.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate this equipment.
Canadian Department of Communications Statement Canadian Department of Communications Statement Canadian Department of Communications Statement Canadian Department of Communications Statement Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.