Poly-Tex EC3001 - Manual (Page 3)

DETAIL A
ASSEMBLY INSTRUCTIONS
3
1. SLIDE END CAP VERTICAL INTO THE END CAP BASE. FASTEN
WITH 5/16" x 2" HEX BOLT, LOCK WASHER, AND HEX NUT.
2. SLIDE THE BOTTOM BENCH OVER END CAP VERTICAL.
ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" x 2" HEX
BOLT, LOCK WASHER, AND HEX NUT.
3. SLIDE THE MIDDLE BENCH OVER END CAP VERTICAL.
ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" x 2" HEX
BOLT, LOCK WASHER, AND HEX NUT.
4. SLIDE END CAP TOP BENCH OVER END CAP VERTICAL.
ALIGN WITH MOUNTING HOLE. FASTEN WITH 5/16" x 2"
HEX BOLT, LOCK WASHER, AND HEX NUT.
5. TO INSTALL THE BOTTOM BENCH SUPPORT INSERT THE
BENT TAB END OF THE TUBE INTO THE BOTTOM BENCH.
6. ALIGN STRAIGHT TAB END OF BOTTOM BENCH SUPPORT
WITH MOUNTING HOLE IN MOUNTING TAB ON END CAP
BASE. FASTEN WITH 1/4" x 1" HEX BOLT, LOCK WASHER,
AND HEX NUT.
7. ATTACH TO ANOTHER EC3001 WITH BOLTS AT
CONNECTING HOLES SEE DETAIL A.
5/16" x 2" HEX BOLT
BASE
SUPPORT TUBE
1/4" LOCK WASHER
1/4" HEX NUT
1/4 x 1" HEX BOLT
BENT TAB END OF
SUPPORT TUBE