Palram Applications Side Louver Window - Manual (Page 2)

If you don’t have the greenhouse assembly instructions, you can download it from
the following link: http://www.palramapplications.com/assembly-instructions.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
This icon indicates that the installer should be inside the greenhouse.
Please read these instructions carefully before you start to
assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
You will need
To assembly this product
(these items not supplied)
Safety
Some parts may have sharp edges. Please be careful when handling
components.
Always wear gloves, eye protection, and long sleeves when assembling
or performing any maintenance on your product.
To prevent injuries, do not allow children to play under the greenhouse
during assembly.
It is highly recommended to be assisted by a second person in some steps.
Sort the parts and check according to the contents parts list.
In case you bought the window kit along with the greenhouse, please install the
kit along with the assembly of the greenhouse and not after the greenhouse was
assembled.
This product is suitable for Palram’s clear and TwinWall greenhouses (not include
Snap&Grow Greenhouses).
•
This kit includes additive clear panel. If you have a TwinWall panels
greenhouse, please remove the panel and trim it accordingly as explained in
Steps 3.2 or 10.2
•
The kit can be assembled in every side (including back side) of the
greenhouse except for panels that are next to the greenhouse’s corners.
(can be installed only in the back side in the 6x4 greenhouses)
•
Prior to the installation, several parts from the greenhouse needs to be
dismantle, it is important to keep them in order to use them later.
•
Please note that from Step 5, these instructions refer to both types of
greenhouse’s glazing.
Step 7 : in order to assemble the window kit
in the back, it is necessary to first dismantle part
of the greenhouse as shown in Step 10.
Tighten all screws when completing assembly.
Periodically check the kit components to assure that it remains stable.
EN
x2
Before Assembly