Master Manufacturing ATV Frame kit - Manual (Page 2)

INTRODUCTION
The purpose of this manual is to assist you in the assembly, operation and maintenance of your sprayer or
accessories. Please read through this manual completely too fully understand how to operate and maintain your
equipment. This product has been manufactured to provide years of dependable service; proper operation and
maintenance will ensure its dependability. Keep your manual in a safe, convenient place for future reference.
Always mention the model and part number in any correspondence.
ASSEMBLY
The ATV frame kit is designed to fit many applications. It has been specifically designed to attach easily to
other Master Manufacturing products. The following instructions are intended for the ATV frame kit to be
attached to a Master Manufacturing 15 or 25 gallon spot sprayer. Please refer to the figure in this manual for
reference to the following assembly instructions.
Frame Assembly
1.) Locate the two tank bottom mounts (PN 31-100140-R & 31-100140-L).
2.) Position the two brackets under the tank as shown in the figure. Attach the brackets to the tank with
four 5/16” washers and 5/16”-18 x ” bolts (PN 33-100115 & 33-100114). Tighten bolts securely
(Do Not over tighten).
3.) Position tank with bottom brackets onto ATV rack and fasten securely with U-bolts directly to slots
in bottom brackets and ATV rack or straps (Not supplied). Warning: Tank must be
securely fastened to ATV to ensure proper handling. Failure to fasten tank to
ATV may lead to injury.
4.) Attach angle brackets (PN 31-100139) to bottom mounts (PN 31-100140-R & 31-100140-L) with 4
our 5/16-18 x 1” bolts (PN 33-103116) and 5/16’ serrated nuts (PN 33-103116).
Boom Mounting
1.) Following directions provided with boom manufacturer, mount boom to angle brackets.
Warnings
Tank must be securely fastened to ATV to ensure proper handling. Failure to
fasten tank securely to ATV may lead to injury.
Tank total weight filled with liquid must not exceed manufactures weight limit for
front or rear racks. Refer to manufacture specifications
WARRANTY PARTS SERVICE
Products sold shall be warranted from defects in workmanship and material when used within the service and
scope for which they were designed for a period of one year from date of purchase. Contact your distributor/
dealer for replacements parts or warranty work. Please have your original sales receipt or other proof of
purchase date when requesting any warranty work.
To ensure the correct parts are acquired always provide the model number of your sprayer/attachment and the
part number and description obtained from the illustrated parts breakdown in this manual.