Asus D2X - Manual (Page 70)

64 ASUS Xonar D2X
10.2 Configuration and Test with RMAA
Start RMAA and follow the setup procedure below.
1. Select both of the playback/recording devices as “ASUS Xonar D2X Audio”.
2. Select 24bit and 48KHz for the test signals. (If you change the format here,
please remember to go back to set the same sample rate output in the Xonar
D2X Audio Center)
3. Click “Test options” button in RMAA and check “Analyze noise and distortion
only in 20Hz-20KHz range” (audio in-band for human hearing) in the General
tab.
1 2
3