Lincoln Electric IM10130 K3149-1 (11860) Wheel Charger - Manual (Page 6)

ASSEMBLY OF HANDLE AND CLAMP
HOLDER
Assemble the charger handle and clamp holder accord-
ing to the following instructions and illustrations.
1. Carefully remove the charger unit and all associated
hardware from carton, note the charger is shipped
with the handle partially secured, and resting in a
down position on the front of the unit.
2. Unscrew the top 2 screws on either side of the
charger. Remove the bottom 2 screws holding han-
dle with the washers (washers will be discarded), as
shown in Figure 1 .
FIGURE 1
3. Then replace the bottom 2 screws by screwing in part
way so the handle can be move to an upright posi-
tion. (See Figure 2)
FIGURE 2
4. Align the holes of the handle with the top 2 screw
holes of the charger. Replace the top 2 screws which
you removed in Figure 1. Tighten all 4 screws secur-
ing the handle in the upright position. (See Figure 3)
ASSEMBLY
TOP
2 SCREWS
HANDLE
REMOVE AND DISCARD
2 WASHERS
BOTTOM
2 SCREWS
REPLACE BOTT OM
2 SCREWS BY
SCREWING IN
PART WAY
ROTATE HANDLE
TO UPRIGHT
POSITION
REPLACE TOP
2 SCREWS THEN
TIGHTEN ALL 4
SCREWS
FIGURE 3
5. Carefully screw the clamp holder together onto the
handle as shown in Figure 4.
FIGURE 4
CLAMP HOLDER
HANDLE
SCREWS
6