beautypg.com

Asus P4B-MX User Manual

Page 44

background image

2-24

Chapter 2: Hardware information

Figure 2-29

USB Header

5. USB header (10-1 pin USB)

If the USB ports on the rear panel are inadequate, a USB header is
available for two additional USB ports. Connect a 2-port USB connector
set to the USB header and mount the USB bracket to an open slot in the
chassis.

6. Infrared module connector (5-pin IR)

This connector supports an optional wireless transmitting and receiving
infrared module. This module mounts to a small opening on system
chassis that support this feature. You must also configure the UART2
Use As
parameter in BIOS to set UART2 for use with IR. See section
“4.4.2 I/O Device Configuration” for details.

Use the five pins as shown in Back View and connect a ribbon cable
from the module to the motherboard SIR connector according to the
pin definitions..

Figure 2-30

Infrared Module Connector

®

P4B-MX

Front View

Back View

+5V

IRTX

IRRX

(NC)

GND

+5V

IRRX

IR

TX

(NC)

GND

IR

1

P4B-MX Infrared Module Connector

®

P4B-MX

USB

1

5

6

10

P4B-MX USB Header

1: USB Power
2: USBP2–
3: USBP2+
4: GND
5: NC

6: USB Power
7: USBP3–
8: USBP3+
9: GND