Atlantis Land A02-RA440 - Manual (Page 29)

ENGLISH
29
Router ADSL2+ and then to the socket. The product will
carry on immediately a diagnosis (60 seconds). Finished this
the Led PWR, SYS (eventually even the Led LAN, if
connected to PCs) will be fixed green. The Led ADSL, if
suitably connected, at first will be flashing and then it will
remain fixed. If the LED ADSL continually flashes You have
to read Note (into section 1.8) in order to solve this problem
1.5 Default Settings
The WebShare VPN Router ADSL2+ can be configured with
your Web browser. The web browser is included as a
standard application in following operation systems, UNIX,
Linux, Mac OS, Windows 95/98/NT/2000/Me, etc. The
product provides a very easy and user-friendly interface for
configuration.
Before Configuration
This section describes the configuration required by LAN-
attached PCs that communicate with the WebShare VPN
Router ADSL2+, either to configure the device, or for
network access. These PCs must have an Ethernet interface
installed properly, be connected to the WebShare VPN
Router ADSL2+ either directly or through an external
Switch, and have TCP/IP installed and configured to obtain
an IP address through a DHCP server or a fixed IP address
that must be in the same subnet of the WebShare VPN
Router ADSL2+. The default IP address of the WebShare
VPN Router ADSL2+ is 192.168.1.254 and subnet mask is
255.255.255.0. The best and easy way is to configure the
PC to get an IP address from the WebShare VPN Router
ADSL2+ (DHCP client).
Please follow the steps below for PC’s network environment
installation. First of all, please check your PC’s network
components. The TCP/IP protocol stack and Ethernet
network adapter must be installed. If not, please refer to MS
Windows relative manuals.