White’s Electronics Prizm 6T User Manual

Page 4

Prizm™ 6T

To Assemble

1. Remove all parts from shipping carton (see diagram next page).

2. Use nonmetallic washers (between round search coil and clevis fiber rod),
and fiber bolt and thumbnut to secure search coil to fiber rod.

3. Unlock Camlock on “S” rod, insert fiber rod into curved rod, line up buttons
into one of adjustment holes. Twist Camlock to LOCK.

4. Unravel search coil cable and wind around rods (first revolution over top of
rod). Plug search coil cable connector into control box. Screw finger tight to
secure. Secure cable to fiber rod near search coil (first revolution) with small
hook and loop strap provided. Allow slight cable slack (prior to first revolution)
to allow search coil tilting.

5. Grip by handle, with arm in elbow cup, and sweep search coil over floor. If
necessary for comfort, unlock camlock, compress buttons and reposition fiber
rod. If necessary, elbow cup is also adjustable for comfort.

6. A large nylon strap is provided. When woven through the slots in elbow cup,
physical leverage and control is provided. Insert strap velcro side up through
right and left slots in the elbow cup. The end tab of the velcro strip bends into a
“T-lock”. Pull strap so that the “T-lock” locks firmly. With arm in elbow cup, pull
strap snug and then fold strap onto itself loose enough for your arm to be
inserted and removed without adjusting the velcro contact.

T-Lock

1234567

Nylon Strap

Arm Cup

Right Slot

Left Slot