beautypg.com

White’s Electronics Bullseye 2 User Manual

Page 2

background image

Introduction

White's 120mm probe length Bullseye is designed to be

used as an aid to target location (pinpointing probe), as well as

for locating wall studs and other near surface metals.

Once the general location has been pinpointed with a

conventional detector, near surface metals can easily be

located with the Bullseye avoiding serious digging altogether.

Deeper metals may require some digging prior to using the

Bullseye.

The Bullseye is an invaluable tool to speed locating the

metal either in the bottom of the hole, the flap of turf, the side

of the hole, or in the pile of dirt removed from the hole. This

can be cumbersome with the conventional metal detector

alone, due to their ever increasing sensitivity, wide scanning

loops and physical size. The Bullseye provides reduced

sensitivity to isolate and recover such metal quickly. Such a

probe would not be useful if it approached the sensitivity

expectations of conventional metal detector models.

The end of the probe is waterproof. However, the Bullseye's

control box is not water proof and must be protected from

moisture/mud. Slip it into zip lock plastic bag on wet days.

The Bullseye is not digging tool, avoid using the probe to

pry metal from the ground.

The sensitivity areas of this probe are the very end of the

shaft protruding from the control box, as well as the sides near

this end, see DETECTON AREA on cover. This allows the

probe to be circled around a hole to determine what side of the

hole the metal is in. The end can be moved over a pile of dirt,

or turf flap. Like a conventional detector "X" the tip of the

probe over the area to find the metals center.