White’s Electronics Coinmaster GT - Manual (Page 5)

Page 5
Coinmaster GT
Owner’s Manual
5. Grip the instrument by the handle, with your arm in the
elbow cup with strap and sweep the loop/search coil over
the floor. If the instrument fit feels uncomfortable, readjust
clevis/lower rod length with spring clip button and cam-
lock so that search coil can be held near the floor without
stooping over.
6. Adjust the elbow cup strap so that it is loose enough for you
to slide your arm in and out without loosening each time
you want to set the detector down. The elbow cup strap pro-
vides extra leverage and control. However, some prefer not
to use it.
7. Install the battery pack.
Batteries
1. Remove the battery pack by pressing both buttons on sides
of battery compartment.
2. Slide open the tray cover. Install eight (8) “AA” alkaline
batteries taking note of correct (+) and (-) positions and
close cover.
3. Slide battery pack into compartment. A vigorous ‘slam’
may be needed to ensure a good seating.
4. Press ON/OFF button. Good batteries will produce a high
pitched beep on power-up. A low pitched beep indicates
low batteries.
5. Batteries that are weak, or become weak during use, will
automatically indicate Low Batt with a battery icon on the
center portion of the display. A three-beep alarm also
sounds to indicate batteries are too low for operation.
6. Most alkaline batteries will give about 25 hours of continu-
ous operation. Battery life will vary with intermittent use,
back-light use, temperature, control settings, target indica-
tions, battery quality, battery condition upon purchase, and