Teka Hydroclean HL 840 - Manual (Page 22)

22
To disable the function, press the + and – sen-
sors at the same time for several seconds
until you hear a beep. Caution
In the event of a power failure, your electronic
clock settings will be erased and 12:00 will
flash on the clock display. Reset the clock and
programme again.
With this function, any grease or dir t that is
stuck to the walls of the oven can easily be
removed through the combined action of
steam and the excellent proper ties of the new
Teka
Hydroclean ® enamel.
Thanks to the new Teka Hydroclean ® techno-
logy, the oven does not need to be cleaned
with a grease removal product. When the
water and dir t are removed, the walls of the
oven are clean and grease-free.
How to use the oven cleaning cycle
Always use the cleaning programme with a
cold oven. Running it with a hot oven may
have adverse effects.
1. First remove the trays and all accessories
from the oven interior, including the tray
suppor ts and telescopic guide rails.
Teka Hydroclean ® Cleaning function
Caution
Do not clean the oven and tray at the same
time using the Teka
Hydroclean ® function as
you will not obtain good results. To clean the
tray, follow the instructions provided later on.
2. With the oven cold, pour 250 ml of water
into the bottom of the oven cavity.
3. Turn the control dial to position .
4. You will hear a beep indicating that the Teka
Hydroclean ® cycle has star ted. Symbol
will flash slowly and the time remain-
ing to complete the cycle will appear on the
display.
IMPORTANT
The duration of this cycle cannot be changed.
To stop the cycle before it is finished, turn the
control dial to position
.
3172483-002 EPIFA.QXD:- 9/9/11 08:03 Página 22