Teka CPEL 15 - Manual (Page 31)

29
EN
Safety Instructions
Warning! Before connecting the appliance
compare the power data (voltage and
frequency) indicated on the characteristics
plate with those of the power supply in
question. If these data do not match there may
be problems. In case of doubt, contact an
electrician.
Warning! If the electrical wire plug is removed,
the appliance must be installed and connected
by a technician. Contact a qualified electrician
who knows and respects current safety
standards. The manufacturer cannot be held
responsible for damage resulting from fitting or
connecting errors.
Warning! The electrical safety of the appliance
can only be guaranteed if it is earthed. The
manufacturer cannot be held responsible for
damage resulting from the absence of or
defects in the installation‟s protection system
(e.g. electrical shock).
Warning! Only use the appliance once it has
been fitted into its built-in position. Only in this
manner can it be guaranteed that users cannot
access the electrical components.
Warning! Never open up the appliance‟s
frame. Possible contacts with electrical
conducting parts or changes to electrical or
mechanical components may represent a
danger to users‟ safety and prejudice the
correct working of the appliance.
Warning! Repairs and maintenance, especially
of parts carrying electrical current, must only be
done by technicians authorised by the
manufacturer.
The manufacturer and
retailers do not accept responsibility for any
damaged caused to people, animals or
property as a result of repairs and maintenance
carried out by non-authorised personnel.
Warning! Repairs undertaken during the
guarantee period must only be done by
technicians authorised by the manufacturer. If
this is not the case then any damage resulting
from the repair in question is excluded from the
guarantee.
Warning! The appliance must be disconnected
from the electrical current when installation and
repair work is being done. To disconnect the
appliance from the current, one of the following
conditions must apply:
- The switchboard fuses / circuit breakers
must be disconnected.
- The plug should be removed from the
socket. To remove the plug from the socket
do not pull on the electric cable but rather
pull out the plug itself directly.