Teka TS 138 - Manual (Page 23)

Warning!
When changing the side at which the door opens, the appliance must
not be connected to the mains. Remove plug from the mains beforehand.
1.Tilt the appliance slightly towards the
rear and prop it securely.
2.Unscrew the door hinge screws and
remove the hinge pin bracket .
3.Open the door a little way and take it
out downwards.
4.Unscrew the upper pin and screw
it into place on the opposite side.
5.Fit the door into the upper pin
and close it.
6.Screw the hinge pin bracket
securely into place on the opposite
side using the screws .
Changing over the freezer compartment door
Open the freezer compartment door a little way.
Using a small screwdriver, press the spring
in the opening of the lower door bearing
slightly upwards and take the door bearing
out complete with the door.
Position the covering cap (M) on
the opposite side.
Turn the freezer compartment door
through 180 and fit the lower door
bearing into the lower bearing
cavity of the freezer compartment
door.
Lift the freezer compartment door
a little way upwards, fit it into the
upper door bearing, and at the
same time insert the lower door bearing into
the square hole.
Small upward and downward adjustments of the freezer
compartment door will make fitting easier.
22