Teka DW8 60 SWB - Manual (Page 14)

User instructions
14
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S TARTING THE PROGRAM ”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
"3/1" OPTION BUTTON
(available in all programs except the soak program)
By pressing the button (5) you activate the "3/1" option, confirmed when
the relative light comes on. This option has been studied for the use of
dishwashing powder or tablets with integrated substances in place of
regenerating salt or rinse-aid known on the market as “3 in 1” or “triple
action” products; in this case the dishwasher will use the product in an
optimal way avoiding salt and rinse-aid consumption, which could
already be found in the dishwasher.
Note: When selecting the "3/1" button, it is normal that the salt and
rinse-aid lights remain on, if their containers are empty.
IMPORTANT:
the option must be disabled manually by pressing button (5).
3/1 products are not suitable for use with excessively hard water.
Therefore, if the water hardness is set higher than H3, the 3/1 OPTION
light (6) flashes to indicate a setting error. This does not prevent the
use of the option, but the washing results might not be of the best.
SPREAD HALF LOAD
(available in all programs except the soak program)
When there are not many dishes to be watched, the “spread half load”
option, controlled by button (7) is useful; it saves water and electricity
and reduces the program’s duration. Place dishes in both baskets then
load the detergent dispenser than less than the normal amount for a full
load..