Installation instructions – Staub Electronics WPS-350-BUL-A WIREPATH - SURVEILLANCE 350-SERIES BULLET ANALOG OUTDOOR CAMERA WITH IR (550 TVL) User Manual

Page 7

WPS-350-BUL-A Installation Manual

INSTALLATION INSTRUCTIONS

1. Prepare Camera for Mounting

Prior to mounting to the Camera, we recommend that the position and

angles be preset in order to speed installation. These settings can be fine-
tuned once the Camera is mounted.

A. Adjust Camera Rotation

B. Adjust Swivel of Camera
C. Adjust Camera Angle

2. Connect the Camera to the System

Recommended Cabling:

- Video RG59 or RG6
- Power Cat5e/6 or 18/2

A. Connect the BNC video output to the video in of a DVR or monitor.

B. Connect the DC Power In to a 12V DC 1A power supply using the included

WPS-ACC-PWR DC power adapter on the wire. The power supply can be
located at the head end of system if you prewire a power wire.

Important Note! Be sure that the polarity and the voltage of the power supply
connection is correct before attempting to power the camera. Backward
polarity or any more than a 12 volt DC power supply will damage the camera.
The power supply used must be rated to 1 amp per output minimum.

12V DC Power

BNC Video

Output

DC Plug