Spigen Steinheil ENHANCED OPTICAL HARD COATED FILM for Laptops - Manual

1. Adjust the position of the film before installation on the
device. The film is made slightly smaller than the actual LCD size
for easier application. (Steinheil™ Screen Protector is designed
to have little margins on four sides so you can adjust or remove
the film easily)
2. Spray the Cleaner Spray on Micro-Fiber Fabric. Clean the LCD
Screen with the fabric. But, DO NOT spray directly on the LCD
Screen . (Clean your hands and make sure the device is stable)
3. Separate about half of the release film layer and start apply-
ing the Steinheil™ Screen Protector on the device. Remove the
rest of the release film layer as you install the Screen Protector
onto the device. (Slightly sweep through the surface of the film
with the provided squeegee to avoid air bubbles)
4. If you find any dust under the film after installation, use
sticky-tape to remove the dust as shown in the picture.
Installation Guide
for Laptops