LevelOne NVR-0216 - Manual (Page 83)

NVR-02 Series User Manual 83
The HDD space recycle function is turned on by default. You can
alternatively turn it off and set a system event in "NVR
Setup">>"Event Configurations">>"Event Trigger">>"Event Handling
Settings">>"When NVR is triggered by", and set a desired disk
remaining space for event trigger condition. You'd have to take action
manually after you get the system event notification, such as replacing
disk, turn on HDD recycle function, or backup recording data.
Users can also set to keep a previous number of days of recording
data by enabling the option below. This is quite often used in
application such as banking which certain countries requires to always
keep a minimum previous number of days of recording data.
* If this option is enabled, once the hard drive is full, the recycle
function will then start but it will ensure that the number of days of
recording data defined here will stay in hard drive instead of wiping
out 20GB of data at a time.
* If the hard drive is not full, the NVR re-calculates twice a day (each
at 2:30am and 2:30pm) to keep the defined number of days of
recording data from these two particular point of time backward.