LevelOne FCS-5042 - Manual (Page 27)

Network Camera User’s Manual
27/56
Network Setting
“LAN” & “PPPoE”
The default type is LAN. Select PPPoE if using ADSL
1. LAN
The default status is Get IP address automatically. This could be tedious to perform
software installation whenever the Network Camera starts. Therefore, once the network
is set, especially for the IP address should be entered correctly. Select Use fixed IP
address then the Network Camera will skip installation. The Network Camera will
automatically restart and operate normally after a power outage. You can run IP installer
to check the IP address assigned to the Network Camera if the IP address is forgotten,
or you can use the UPnP function provided by the Network Camera (MS Windows XP
provides UPnP function at My Network Place).
(1) “Get IP address automatically”
(2) “Use fixed IP address”
- “IP address”: This is necessary for network identification.
-
“Subnet mask”: This is used to determine if the destination is in the
same subnet. The default value is ―255.255.255.0‖.
-
“Default router”: This is a gateway used to forward frames to
destinations in a different subnet. Invalid router setting will fail the
transmission to destinations in different subnet.
-
“Primary DNS”: The primary domain name server that translates
hostnames into IP addresses.
-
“Secondary DNS”: Secondary domain name server backups the Primary
DNS.
-
“Enable UPnP presentation & port forwarding”: Enable UPnP ability.
-
“Http port”
This can be typed besides the default Port 80. Once the port is
changed, the users must make sure the change for the connection is successful.
For instance, when the Administrator changes the HTTP port of the Network
Camera which IP address is 192.168.0.20 from
80 or 1025 to 65535, the users
must type in the web browser ―http://192.168.0.20:8080‖ instead of
―http://192.168.0.20‖.
-
“RTSP Port”
RTSP port can be typed besides the default Port 554
- “RTP Port” The RTP port can be typed besides the default Port 54
Note: Please set Video RTP port in even number after default value port 54. Then,
Video RTCP pot、Audio RTP port、Audio RTCP port will automatically set the
values in ascending.
-
“RTSP Streaming access names”
The RTSP streaming currently supports
video only, audio only, and audio/video. To use the audio/video stream, type the
URL as
―rtsp://61.30.125.43/liveN.sdp‖.
2. PPPoE
If using the PPPoE interface, you should fill the following settings from ISP.
(1) “User name”: The login name of PPPoE account
(2) “Password”: The password of PPPoE account
(3) “Confirm password”: Input password again for confirmation