LevelOne FCS-3101 - Manual (Page 27)

Network Camera User’s Manual
27/54
Network
Any changes made on this page will restart the system in order to validate the changes.
Make sure every field is entered correctly before clicking on
“finish”
Network Setting
“LAN” & “PPPoE”
The default type is LAN. Select PPPoE if using ADSL
1. LAN
The default status is Get IP address automatically. This could be tedious to perform
software installation whenever the Network Camera starts. Therefore, once the network
is set, especially for the IP address should be entered correctly. Select Use fixed IP
address then the Network Camera will skip installation. The Network Camera will
automatically restart and operate normally after a power outage. You can run IP installer
to check the IP address assigned to the Network Camera if the IP address is forgotten,
or you can use the UPnP function provided by the Network Camera (MS Windows XP