Atlantis Land A02-WS1 GX01 - Manual (Page 33)

ENGLISH
WebShare System 33
POWER (jack)
Connect the supplied power adapter to this jack.
POWER( Switch)
A Power ON/OFF switch.
1.4 Cabling
First you must connect the product to the ADSL line through the RJ11
cable you have in equipment (in the port LINE), then connect to the RJ45
ports the PCs of your Lan or others Switch. You can get to the Wireless
Router through the different client wireless compatible with the
IEEE802.11b & IEEE802.11g standard (please check 1.9). In the end
connect the AC Adapter to the Wireless Router ADSL2+ and then to the
socket. Once you’ve checked all the connections and you’ve switched on
the Wireless Router ADSL2+ the product will carry on immediately a
diagnosis (60 seconds). Finished this the Led PWR, SYS (eventually even
the Led LAN, if connected to PCs) will be fixed green (WLAN is blinking
when wireless module is loaded) . The Led ADSL, if suitably connected, at
first will be flashing and then it will remain fixed. You have to read Note
(into section 1.8) in order to solve this problem
1.5 Default Settings
The WebShare Wireless Router ADSL2+ can be configured with your Web
browser. The web browser is included as a standard application in
following operation systems, UNIX, Linux, Mac OS, Windows
95/98/NT/2000/Me, etc. The product provides a very easy and user-friendly
interface for configuration.
Before Configuration
This section describes the configuration required by LAN-attached PCs that
communicate with the WebShare Wireless Router ADSL2+, either to
configure the device, or for network access. These PCs must have an
Ethernet
interface installed properly, be connected to the
WebShare Wireless Router ADSL2+ either directly or through an external
repeater hub, and have TCP/IP installed and configured to obtain an IP
address through a DHCP server or a fixed IP address that must be in the
same subnet of the Wireless ADSL Router. The default IP address of the