IPA Tools 9001 Pulsar Master Kit - Manual (Page 4)

3
The USER is responsible for using the PULSAR ™ in accordance
with manufacturer’s specifications and recommendations.
This tool could be damaged or could damage the circuits (such
as vehicle computers, modules and other sensitive equipment)
when used improperly or on the wrong circuit.
WARNING: The PULSAR ™ may be used to power up circuits which
may control moving devices. i.e. fan motors, starts etc. Be sure to
keep hands and feet, tools and equipment away from any moving
parts at all times. Be sure to WEAR SAFETY GLASSES to protect
yourself from projectiles and other dangers. Be careful when
using the PULSAR
™ not to accidently power up a piece of
equipment and hurt yourself or the tool. The manufacturer is not
liable for improper use of this tool.
NOTE TO USER
The PULSAR ™ is a powerful tool for trouble-shooting automotive
wiring problems. The User is responsible for reading the entire
instruction manual and following basic responsible procedures
when troubleshooting vehicle electrical circuits. Vehicle
manufacturer’s specifications and warnings should be adhered to
at all times. Before using the PULSAR
™ on a vehicle, you should
practice with the tool in a controlled environment to become
familiar with the various functions.
When used properly, it helps to
troubleshoot short circuits, parasitic draws, relay circuits, bench
test equipment, install aftermarket electrical components and be
an asset for general wiring repairs. When used improperly it can
damage electrical equipment including, wiring, control modules
and computers. WARRANTY DOES NOT COVER ANY DAMAGE
RESULTING FROM IMPROPER USE OF THE TOOL.
When using this tool, watch for smoke or excessive heat from the
tested circuit or the PULSAR
™ . The housing should never feel hot
to the touch. If it feels hot, immediately shut down the unit and
call technical support. In certain cases of high amperage draw,
the PULSAR
™ wires and adapters may begin to feel warm. This is
normal but if they feel hot to the touch or begin to melt,
immediately shut down the PULSAR
™ and call the manufacturer/
technical support at 888-786-7899. Always keep wires and
adapters away from hot engine components, fan motors or moving
parts which may damage the tool or wiring.