Inter-M DAC-288 - Manual (Page 7)

DANTE AMPLIFIER CONTROLLER
5 DAC-288
Rear Panel Rear Panel
1. AC INPUT
AC Input terminal (Power supply is AC 120V - 240V, 50/60Hz)
2. POWER SWITCH
Power switch for on/off.
3. DC INPUT
This is a terminal to connect a preliminary battery(24VDC) for emergency. The device is operated via
connected preliminary battery during a blackout from AC power.
24VDC -- input supplies power to set regardless of power switch on/off.
4. DRY CONTACT INPUT AND OUTPUT TERMINAL
If inputting a dry contact signal into the contact terminal of transmitter, the dry contact signal is outputted in
its contact output terminal of receiver.
Input contact: A dry contact signal can be inputted if making short each channel's pin.
Output contact: The same signal as input contact of transmitter outputs.
※ Note: A dry contact signal is transmitted only when the device is normally operating and please input the
signal once you complete to check its operating status.
Input signal is not transmitted when the power is off because data is sent in real time.
Each device can transmit or receive only and is impossible to be duplicated for its use.
PRIMARY SECONDARY
SYNC
AC INPUT
POWER
RS-232 OFF ON DC INPUT
24V 500mA CH 8
H C E
OUTPUT (0dBu / 10k ) NETWORK
1 2 3 4 5 6 7 8
CONTACT OUTPUT
CONTACT INPUT
LIVE
1 2 3 4 5 6 7 8
CH 7
H C E
CH 6
H C E
CH 5
H C E
CH 4
H C E
CH 3
H C E
CH 2
H C E
CH 1
H C E
CH 8
H C G
CH 7
H C G
CH 6
H C G
CH 5
H C G
CH 4
H C G
CH 3
H C G
LINE INPUT (0dBu / 10kΩ)
CH 2
H C G
LINE / MIC
LEVEL
MIN MAX
LEVEL
MIN MAX
OFF ON
CH 1
PHANTOM PHANTOM
H C G
AUX
OFF ON
5 8
9
Output
Input
DAC-288_E:DAC-288_E 1/20/14 11:44 AM Page 8