AT&T 1070 speakerphone - Manual (Page 10)

4
SPECIAL OPTIONS
LEVEL-4
LCD CONTRAST
Getting started
Display screen messages
AC FAIL There is no AC power to the set. If a good battery is
installed, basic phone operation is supported, (such
as making and answering calls on the handset.)
Speakerphone, headset and call privacy are not
supported. The handset volume will be at the minimum
level and only the two lowest levels will be available for
the ringer volume.
COVM The telephone is ready to receive a voice mail signal from
your local telephone company.
COVM
1 2 3 4 There are new voice mail messages.
DND The Do Not Disturb mode is on.
continued on next page
LCD CONTRAST
Your set's display provides important information.
You can adjust the screen contrast to one of eight
levels to optimize readability in different lighting
conditions.
1. Press [ENTER].
2. Press [ ] or [ ] until you see SPECIAL OPTIONS.
Press [ENTER].
3. Press [ ] or [ ] until you see LCD CONTRAST.
4. Press [ ] or [ ] to select the screen contrast
level (1-8).
5. To move to the next feature, press [ ].
-OR-
To exit setup, press and hold
[ENTER].
DTAD: XX/YY Flashes when the mailboxes of the DTAD mailbox 1080
telephone are full or when the auto attendant of the DTAD
mailbox 1080 telephone is off. (XX is the total number of
new system extension messages recorded for this 1070
telephone. YY is the total number of all system extension
messages recorded for this 1070 telephone.)