Arcam CD62 - Manual (Page 6)

CD62
6
Using the CR224 remote control
DISP (Display)
Turns the display on or off. Turning the display off generally
produces a slight improvement in sound quality.
A–B
This button enables you to repeat any section of music
within a track. Whilst the disc is playing, press the
A–B
button at the start of the section you wish to repeat.
‘REPEAT’ is shown on the display and the letter ‘A–’ fl ashes.
Press the button a second time when you reach the end
of the section you wish to repeat. The ‘A–B’ letters stop
fl ashing and remain lit. This section will repeat until you
press or
or . The forward search button ( )
moves forward within the selected loop.
REPEAT
To repeat the entire CD or a pre-programmed selection of
tracks press
REPEAT once: ‘REPEAT’ lights on the display.
To repeat a particular track, select that track and then press
REPEAT twice so that ‘REPEAT 1’ is shown on the display. If
you now select a different track, that track is repeated
instead.
To cancel the repeat function press REPEAT a third time.
TIME
Press TIME once to display the remaining time of
the currently playing track. Press again to display the
time remaining on the disc. Press a third time to
turn the text display on.
Press TIME again and the display reverts to its original
setting, showing the time elapsed for the current track.
For CDs with text, pressing TIME once while the disc
is loaded but not playing displays the artist’s name.
Pressing TIME a second time displays the total number of
tracks and the total playing time.
0–9 keypad
This allows direct access to individual tracks on the disc.
To select a track, press the corresponding keypad button.
For tracks greater than 9, enter the digits in sequence. For
example, to play track 15, press and hold
1 until the number
on the display moves to the left, then press 5 .
PROG (Program)
You can program a selection of up to 24 tracks from a disc
to play in any order. Select a track by using the and
buttons, then press PROG to program the track into memory
(‘PROGRAM’ appears on the display to indicate that you have
started programming a sequence). Repeat these steps to
program the remaining tracks in your selection. Alternatively,
press PROG once and enter your track selection using the
0–9 keypad.
The display shows the track numbers programmed, the total
length of the programmed sequence and the number of tracks
programmed (shown by a number below the word ‘STEP’).
Each time you enter a track the number below ‘STEP’
increments by one and fl ashes until you press PROG to confi rm.
If you fail to press PROG within about fi ve seconds the display
stops fl ashing and you will have to reselect the track.
Press to play the program. Press again to replay the entire
sequence from the start. Press and hold CLEAR to erase the
programmed sequence. Press PROG again to exit the program
facility: the display fl ashes ‘CONTINUE’ and shows ‘0’.
MUTE
Stops sound to the speaker outputs of certain Arcam
amplifi ers.
VOL (Volume) +/–
Adjusts the volume on Arcam remote-controllable amplifi ers.
Note that the volume (+/–) controls and MUTE button have
no effect on the audio output level of the CD players.
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on
the CD player (where the IR receiver is located), or the
remote control may not work.
OPEN
Opens and closes the CD tray.
Skip and Search Track
Skip track backwards and forwards;
Search backwards and forwards (see page 5)
Playback control
Play, Stop and Pause (see page 5).
SHUFFLE
Press once to shuffl e play CD tracks (i.e. play them in
a random order). Press again to cancel shuffl e play.
Source selection
These operate in the same way as the source selector
on the front panel of an Arcam integrated amplifi er.