HTP Oil-Fired Water Heater - Manual (Page 3)

3
FOR THE INSTALLER
Installation or service of this water heater must be performed by licensed professionals where plumbing,
air supply, venting, oil burner license and electrical work are required.
Valves that reduce point-of-use temperature by mixing cold and hot water, as well as inexpensive devices
that attach to faucets and limit hot water temperatures, are available. These valves or devices may be
required in your area. Check local code requirements.
The installer should be guided by instructions furnished with the heater, local codes and utility company
requirements. Preference should be given to codes and requirements where they differ from the heater
furnished instructions.
Additional publications which should guide the installer include:
The latest version of the National Fuel Gas Code, ANSI Z223.1, from American Gas Association
Laboratories, 8501 East Pleasant Valley Road, Cleveland, OH 44131.
In Canada
– CGA No. B149 (latest version), from Canadian Gas Association Laboratories, 55 Scarsdale
Road, Don Mills, Ontario, Canada M3B 2R3.
Code for the installation of Heat Producing Appliances (latest version), from American Insurance
Association, 85 John Street, New York, NY 11038.
The latest version of the National Electrical Code, NFPA No. 70.
In Canada, refer to Canadian Electrical Code C 22.1, from Canadian Standards Association, 5060
Spectrum Way, Suite 100, Mississauga, Ontario, Canada L4W 5N6.