Adcom GTP-860II - Manual (Page 17)

| ADCOM GTP-860 II Owner’s Manual 16 17 ADCOM GTP-860 II Owner’s Manual |
[47] AM Button
In main and tuner mode, buttons are
pre programmed to select the AM
band.
[48] FM Button
In main and tuner mode, buttons are
pre programmed to select the FM
band.
[49] M1, M2, M3, M4
(Macro Keys)
These buttons are programmable for
use with any source.
[50] Sleep Button
Press sleep to make the GTP-860 II
automatically switch off after a pre-
set number of minutes. Pressing the
sleep button once will set the sleep
time to 90 minutes, after which the
GTP-860
II will automatically switch
off into Standby mode. Sleep mode is
shown on the Display Panel. To adjust
the Sleep Delay, press the sleep but-
ton, each consecutive press will
reduce the sleep time in 30-minute
increments, as shown in the Display
Panel. To cancel the sleep mode, con-
tinue pressing the sleep button until
the sleep time returns to 0 minutes.
Pressing the power on the front panel
[1] or Stand-By button will also cancel
the sleep mode.
[51] Backlight Button
No programming capabilities. This
button backlights all keys for eight (8)
seconds when pressed.
[52] Dim Button
In main mode, button is pre pro-
grammed to dim GTP-860
II’s informa-
tion display.
[53] Main Button
In all modes, button provides access
to the GTP-860
II. For instance, to
turn on the test tone generator first
push [53] the main button, then push
[39] the test button.