Sotera KIT 400KTF0237 - Manual

INSTALLATION:
If there is a raised plastic notch on the
nozzle, carefully remove it with a file before installing the Anti-Drip Nozzle Spout. Apply soapy water to the end of the nozzle to aid in the installation. Place the
Anti-
Drip Nozzle Spout
on the nozzle as shown. T
ap on the spout with a rubber mallet until it is fully engaged. The
space between the end of the spout (
A
) and the bend on the nozzle (
B
) should be slightly more than 1 3/4” when
pressed on fully
, as shown.
USE:
Place the nozzle into the container to be filled
before
turning on the pump. After pumping, shut off the
blue handled valve then gently shake the nozzle
before
removing it from the container
. The spout will open when
it feels a pressure greater than one (1) pound per square inch (p.s.i.).
Flow restriction will be minimal.
400F1391 Rev
. 2 ECN 004668
If you have any problems, please call
at
(260) 747-9060.
For use with Norwesco and
other nozzles with a 1 3/16” outside diameter
400KTF0237
Anti-Drip Nozzle Spout
F0237
ANTI
-DR
IP
NO
ZZ
LE
SPO
U
T
NO
ZZLE
A
B