Sonnet Technologies Echo Express III-R - Manual (Page 11)

19. OPTIONAL STEP: If you are also installing the Echo Express III-R
Mobile Rack Kit, refer to its user’s guide now for instructions about
installing it and the inner assembly. Otherwise, go to the next step
20. Gently push the inner assembly back inside the rackmount enclosure
(Figure 7).
21. Secure the inner assembly to the rackmount enclosure using the four
screws you removed previously (Figure 7).
22. Connect a Thunderbolt cable between either Thunderbolt port on
the Echo chassis and a Thunderbolt port on your computer (or other
Thunderbolt device in the chain connected to the computer). If you
are daisy chaining additional Thunderbolt devices, connect another
Thunderbolt cable between the downstream device and the open
Thunderbolt port on the Echo chassis
(Figure 8).
23. Using a Phillips screwdriver, secure the Thunderbolt cable(s) to
the Echo Express III-R with the supplied Thunderbolt cable lock
(Figure 8). Note that if you are using an optical Thunderbolt cable, the
supplied Thunderbolt cable lock is not compatible, and you should skip
to the next step.
24. Connect the included power cord between a wall outlet or power strip
and the Echo chassis’ power socket. Note that the power indicator on
the Echo Express III-R will not light until the computer, and any other
Thunderbolt device connected between it and the Echo chassis, is
powered on.
Chapter 3 – PCIe Card Installation and Chassis Setup Steps
Figure 7
7
Figure 8