Sonnet Technologies Echo Express SE II - Manual (Page 11)

7
Chapter 3 – PCIe Card Installation and Chassis Setup Steps
Figure 7
13. Turn the Echo chassis right-side-up.
14. Connect a Thunderbolt cable between either Thunderbolt port on the
Echo chassis and a Thunderbolt port on your computer (or other
Thunderbolt device in the chain connected to the computer). If
you are daisy chaining additional Thunderbolt devices, connect
another Thunderbolt cable between the downstream device and
the open Thunderbolt port on the Echo chassis.
15. Using a Phillips screwdriver, secure the Thunderbolt cable(s) to
the Echo Express SE II with the supplied Thunderbolt cable lock
(Figure 7). Note that if you are using an optical Thunderbolt cable,
the supplied Thunderbolt cable lock is not compatible, and you
should skip to the next step.
15. Connect the included power cord between a wall outlet or power strip
and the power adapter; verify the connector is plugged in securely. Note
that the power adapter’s power indicator will light at this time.
16. Connect the power adapter cable to the Echo Express SE II’s 12V power
socket. Note that the power indicator on the Echo Express SE II chassis
will not light until the computer, and any other Thunderbolt device
connected between it and the Echo chassis, is powered on.