Sonnet Technologies Fusion R800RAID (Without Drives) - Manual (Page 4)

1. Remove the Fusion R800RAID from its packaging, and place it on
a flat, level surface.
2. Carefully pull out each of the transport shims securing the drive
modules in the enclosure. (Figure 3).
3. If you intend to place the Fusion enclosure on a desktop or other
flat surface, attach the included adhesive-backed feet to the
bottom of the enclosure.
(Figure 4).
4. Push a lever release button toward the right until the lever pops
out, and then pull the lever toward you to slide out and remove a
drive module
(Figure 5).
5. Remove a SATA drive from its packaging and set it in on a flat,
level surface with the label side down. Open the supplied tube
of threadlocker and apply a single drop to each of the four screw
holes on the bottom of the drive
(Figure 6).
Figure 5
Figure 4
Figure 3
Drive Installation and Enclosure Setup
shim
foot
shim shim shim
Support Note: Save the shims! If you intend to transport the
Fusion enclosure in such a way that it will be subject to vibration,
you must reinsert the shims under the bottom of the drive modules in
order to prevent them from moving during transport.
drive tray lever
lever release
button
Support Note: It is possible that the drive modules may have
shifted during shipping. To ensure good connections between
the drives and their connectors, remove and reinstall each drive module
before powering on the enclosure.
WARNING: When handling computer products, take care to
prevent components from being damaged by static electricity;
avoid working in carpeted areas. Handle hard drives only by their
edges and avoid touching connector traces and component pins.
shim shim shim shim
Figure 6
screw hole
screw hole
screw hole
screw hole
threadlocker