Sonnet Technologies Fusion D800P2 (Without Drives) - Manual (Page 5)

6. Carefully slide the drive module into the enclosure until its lever
starts to close, and then push the lever in until it clicks to secure
the drive module inside the enclosure
(Figure 7).
7. Repeat steps 2-6 for additional drives.
8. Connect the supplied locking eSATA data cables between the
enclosure and the SATA host controller in your computer; verify
the connectors are plugged in securely (Figure 8).
9. Connect the supplied power cable between the Fusion D800P2
and a grounded wall outlet or power strip; verify the cable is
plugged in securely.
10. Push the switch on the back of the enclosure to the on position,
and then power on your computer.
11. Format the drives installed in the Fusion D800P2 according to
your needs; refer to your operating system software’s guide or
help section for more information.
Drive Installation and Enclosure Setup
Figure 8
locking eSATA
connector
locking eSATA
connector
5
WARNING: When inserting drive modules into the enclosure,
do not force the levers closed. If a lever does not close easily,
remove and reinsert the module, and then push the lever in again.
Figure 7
push lever
until it clicks
push tray in
until the lever
starts to close
Support Note: The supplied Sonnet locking eSATA cables
are compatible with all eSATA ports and provide a far more
secure connection when used with Sonnet drive enclosures and host
controller cards with the matching connectors. If necessary, you may
remove the locking mechanism from the connector by removing the
screws securing the two halves.