Sonnet Technologies Fusion D800RAID (Without Drives) - Manual (Page 5)

6. Carefully slide the drive module into the enclosure until its lever
starts to close, and then push the lever in until it clicks to secure
the drive module inside the enclosure
(Figure 7).
7. Repeat steps 2-6 for additional drives.
Connect Fusion D800RAID Drive Enclosure to Sonnet
RAID Controller
This section describes the connection of the Fusion D800RAID drive
enclosure to the Sonnet RAID controller card.
1. Connect the Infiniband end (with thumbscrews) of the
supplied data cables to the Infiniband ports on the enclosure;
use the thumbscrews to secure the connectors (Figure 8). For
identification purposes, refer to the cable connected to the top
port of the enclosure as “cable B”, and the cable connected to the
bottom port as “cable A”.
2. Connect the mini-SAS end of “cable A” to the mini-SAS port
labeled “A” on the Sonnet RAID controller card; verify the
connectors are plugged in securely (Figure 9). Repeat with “cable
B”.
3. Connect the supplied power cable between the Fusion
D800RAID enclosure and a grounded wall outlet or power strip;
verify the cable is plugged in securely.
4. Push the switch on the back of the enclosure to the on position,
and then power on your computer.
5. Format the drives installed in the Fusion enclosure according
to your needs; refer to the Configuration Tool and Utilities
Operation Manual for more information.
Drive Installation and Enclosure Setup
Figure 9
Figure 8
Infiniband
connector
Infiniband
connector
mini-SAS
connector
mini-SAS
connector
port A port B
A
B
A B
5
WARNING: When inserting drive modules into the enclosure,
do not force the levers closed. If a lever does not close easily,
remove and reinsert the module, and then push the lever in again.
Figure 7
push lever
until it clicks
push tray in
until the lever
starts to close