Rivers Edge RE760 Replacement Strap Kit - Manual (Page 2)

HuntRiversEdge.com
Rivers Edge Treestands, Inc.
1690 Elm Street; P.O. Box 755
Cumberland, Wisconsin 54829
800-450-3343 • Fax (715) 822-2124
E-mail: [email protected]
Replacement Strap Kit (RE760)
HuntRiversEdge.com
TREESTANDS
USE INSTRUCTIONS
1. At desired height, attach by following instructions - a,b,c,d,e.
NOTE: Stand should be attached to tree with platform folded in an
upright position!
a. Lengthen strap by pulling buckle away from strap - this will allow strap to
slide around buckle roller.
b. Take buckle and wrap around tree. Be sure the strap is even and at the
same level all the way around the tree. Also, be sure there are no twists in
the strap. Connect hook to opposite side of stand by inserting thru hole (slot)
provided.
SEE fIgURE 3.
c. Pull on excess end of strap firmly - snugging up stand to tree. SEE fIgURE
3.
NOTE: Platform must be folded up while doing this.
d. Once securely attached, pull stand platform down. This lever-action will
snug stand up tight to tree to prevent any shifting. Redo as necessary to
accomplish a snug stand-to-tree fit. All (4) contact bars must be touching
tree!
SEE fIgURE 4.
e. The tension on strap will not allow any slippage due to roller bar tension of
buckle. Proper installation should be checked prior to stepping onto platform
to ensure safety.
SEE fIgURE 4.
2. Before stepping down onto center of stand platform, be sure it is secured
properly and is tight against tree with all (4) contact bars touching tree!
3. Carefully step onto stand platform to be sure you have a solid feel against tree
and platform is level. Seat folds down for sitting and tips back for standing.
NOTE: To remove stand, fold platform back up and pull on buckle hand
strap.
fIgURE 3
fIgURE 4
TREE
TREE
TREE
waRNINg
REaD, UNDERSTaND aND fOllOw all aSSEmbly,
INSPECTION, maINTENaNCE & USE INSTRUCTIONS
PROVIDED bEfORE EaCH USE. faIlURE TO fOllOw
all waRNINgS aND INSTRUCTIONS COUlD RESUlT
IN SERIOUS INJURy OR DEaTH.
THIS REPlaCEmENT STRaP aSSEmbly IS DESIgNED
TO wORK ONly ON RIVERS EDgE baNDIT, bIg fOOT,
aND lITE fOOT mODEl SERIES TREESTaNDS. DO
NOT USE THIS REPlaCEmENT STRaP aSSEmbly ON
aNy OTHER bRaND OR PRODUCT.
DOUblE CHECK aSSEmbly STEPS TO bE CERTaIN
yOU HaVE CORRECTly aSSEmblED THIS PROD-
UCT.
DO NOT TwIST STRaP wHEN aTTaCHINg. SEE fIg-
URE 3 fOR CORRECT aTTaCHmENT.
alwayS ClImb TREE ON THE aTTaCHmENT SIDE Of
THE TREE STaND. VISUally INSPECT yOUR CON-
NECTION TO bE aSSURED yOU HaVE CORRECTly
aTTaCHED STaND TO TREE aS PER INSTRUCTIONS
aND DIagRamS.
PlaTfORm mUST bE fOlDED UP TO REmOVE STaND.
THIS allOwS SlaCK IN STRaP fOR REmOVal.
NEVER PUll yOURSElf UP ONTO PlaTfORm - al-
wayS STEP DOwN fROm abOVE.
NEVER TOUCH OR mOVE bUCKlE wHIlE STaND IS
IN USE.
NEVER aTTaCH TO a DEaD, ODD-SHaPED, lEaN-
INg, DISEaSED, lOOSE-baRKED TREE OR UTIlITy
POlES.
THE USE Of a lINEmaN'S/ClImbINg bElT IS RE-
QUIRED wHIlE aSCENDINg, DESCENDINg aND IN-
STallINg a HaNg-ON TREESTaND TO STabIlIZE
THE USER wITH THE TREE.
CORRECT TIgHTENINg aND aDJUSTmENTS Of
CHaINS, CablES, STRaPS, ETC. aRE CRITICal TO
STablE HaNg-ON TREESTaND INSTallaTION. all
TREESTaND CONTaCT POINTS mUST bE IN CON-
TaCT wITH THE TREE bEfORE yOU STEP ONTO yOUR
STaND.
NEVER lEaVE a TREESTaND IN a TREE wHEN NOT
IN USE SINCE wEaTHER OR aNImalS COUlD CaUSE
DamagE. TREE gROwTH CaN alSO STRESS aND
DamagE STRaPS aND bUCKlES.
REPlaCE aNy aND all TREESTaND STRaPS EVERy
TwO yEaRS OR wHEN aNy SIgNS Of DamagE OR
wEaR ExIST bEfORE.