Ariens 911134 - LM21SW - Manual (Page 18)

GB - 18
SERVICE POSITION
Put unit into service position for easy access
to underneath the deck.
1. Place unit on a flat, level surface.
2. Disconnect spark plug wire.
3. Remove fuel cap, place a piece of
plastic bag over the opening and tighten
cap securely.
4. Tip unit onto right side (911102, 911132,
133, 134, 141).
Tip unit onto left side, opposite the
discharge opening (911139).
Make sure unit is secure and will not tip
over.
IMPORTANT: Remove plastic from fuel cap
after unit is upright and service is complete.
HANDLEBAR HEIGHT
To adjust (Figure 13 and Figure 14):
1. Place a hole at the bottom of the braces
over the pins on the bracket.
2. On 911102, 141, use the fasteners to
attach one of the holes at the top and
one of the holes at the bottom.
NOTE: To fold handlebars flat for storage,
pull the speed control rod (if equipped) all the
way back, disconnect braces from support
bracket, and fold handlebar forward. Do not
bend speed control rod.
SERVICE AND ADJUSTMENTS
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
CAUTION: Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS clean
up any spilled fuel.
Figure 13
Pin
Hole
OM1800
Figure 14
1. Handlebar
2. Adjustment Hole
3. Support Bracket 4. Fasteners
5. Brace
911102, 141
5
1
3
4
4
2
2
OM1660