Finish Thompson LS-JRE - Manual (Page 7)

CHEMICAL REACTION DISCLAIMER
The user must exercise primary responsibility in selecting the product’s materials of construction, which are compatible with the
fluid(s) that come(s) in contact with the product. The user may consult Finish Thompson, Inc. (manufacturer) and a manufacturer’s
representative/distributor agent to seek a recommendation of the product’s material of construction that offers the optimum avail-
able chemical compatibility.
PROBLEM: Lid pops up.
POSSIBLE CAUSES:
• Discharge hose is submersed in the distilled solvent. Prevent the distillate from filling up to the hose’s level in the receiving
pail.
• Condenser clogged with residue. Clean the condenser and all distillate plumbing.
• Air pocket under the Stilbag. Reinstall a Stilbag correctly (refer to the “Operating the LS-Jr” section of this manual.
PROBLEM: Water contaminating the clean, distilled solvent.
POSSIBLE CAUSES:
• Water in dirty solvent (feed material). Eliminate source of water contamination from the feed material.
• Acid or caustic corrosion in the condenser from an unsafe pH. Neutralize the solvent to a pH between 6 and 9 (refer to the
“Operating the LS-Jr” section of this manual).
• Water was left to freeze in the condenser. Locate the LS-Jr in an area above 32°F.
COMMON SPARE PARTS
PART NUMBER DESCRIPTION PART NUMBER DESCRIPTION
M101828 Stilbags - Reg. (per dozen) J101167 Condenser (standard)
M101829 Stilbags - Hi-temp (per dozen) A100551 Condenser Kit (includes hoses)
M101055 Stilbag Retaining Ring A102085 Condenser (stainless steel)
A100552 Lid Gasket (four 50’ rolls) M100931 Discharge Hose
A100422 Grounding Clamp/cable J102457 On/off Switch contact block
J102261 Water Quick-connects Male J102795 Temperature Control Board
J100038 Water Quick Connect Female
WARRANTY
Finish Thompson, Inc (manufacturer) warrants this product to be free of defects in materials and workmanship for a period of 3 years
plus a lifetime warranty on the LS Heater, with the exception of the PTFE vessel coating which carries a 1 year warranty, from date
of purchase by original purchaser. If a warranted defect, which is determined by manufacturer’s inspection, occurs within this period,
it will be repaired or replaced at the manufacturer’s option, provided (1) the product is submitted with proof of purchase date and (2)
transportation charges are prepaid to the manufacturer. Liability under this warranty is expressly limited to repairing or replacing the
product of parts thereof and is in lieu of any other warranties, either expressed or implied. This warranty does apply only to normal
wear of the product or components. This warranty does not apply to products or parts broken due to, in whole or in part, accident,
overload, abuse, chemical attack, tampering, or alteration. The manufacturer accepts no responsibility for product damage or per-
sonal injuries sustained when the product is modified in any way. If this warranty does not apply, the purchaser shall bear all cost for
labor, material and transportation.
Manufacturer shall not be liable for incidental or consequential damages including, but not limited to process down time, transporta-
tion costs, costs associated with replacement or substitution products, labor costs, product installation or removal costs, or loss of
profit. In any and all events, manufacturer’s liability shall not exceed the purchase price of the product and/or accessories.
7