20 chapter 1: product introduction – Asus P4PE-X/TE User Manual
Page 30
1-20
Chapter 1: Product introduction
9. USB header (10-1 pin USB_56)
If the USB ports on the rear panel are inadequate, a USB header is available
for additional USB ports. The USB header complies with USB 2.0 specification
that supports up to 480 Mbps connection speed. This speed advantage over
the conventional 12 Mbps on USB 1.1 allows faster Internet connection,
interactive gaming, and simultaneous running of high-speed peripherals.
You may connect an optional USB 2.0/GAME module, connect the USB cable
to this header. The module has two USB 2.0 ports that support the next
generation USB peripherals such as high resolution cameras, scanners, and
printers.
P4PE-X/TE
®
P4PE-X/TE USB 2.0 Header
USB_56
USB+5V
LP5-
LP5+
GND
NC
USB+5V
LP4-
LP4+
GND
1
1.
The USB2.0/GAME module is purchased separately.
2.
Make sure to install the USB driver before using USB devices.
8. CPU and chassis fan connectors (3-pin CPU_FAN1, CHA_FAN1)
The fan connectors support cooling fans of 350mA~740mA (8.88W max.) or a
total of 1A~2.22A (26.64W max.) at +12V. Connect the fan cables to the fan
connectors on the motherboard, making sure that the black wire of each cable
matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Lack of sufficient
air flow within the system may damage the motherboard components. These
are not jumpers! DO NOT place jumper caps on the fan connectors!
P4PE-X/TE
®
P4PE-X/TE 12-Volt Fan Connectors
CPU_FAN1
CHA_FAN1
GND
Rotation
+12V
GND
Rotation
+12V