World Dryer Electric-Aire LN - Manual (Page 2)

2
Unpacking
Models Type Electrical Input* Amperage Watts
LN Automatic 115 VAC, 50/ 60 Hz 10 1150
LN Automatic 208 VAC, 50/ 60 Hz 6 1150
LN Automatic 230 VAC, 50/ 60 Hz 5 1150
Models Nozzle Drying Cycle Dimensions (WxDxH) Weight
LN Integral Automatic 11.59” x 10.75” x 4.90” 294 mm x 273 mm x 124 mm 8 lbs / 3.6 kg
Failure to disconnect the power source before installation or servicing can
result in serious injury or death from electric shock.
Failure to properly ground this unit could result in severe electrical shock
and/or death.
Risk of fire, personal injury or property damage are possible if local codes,
NEC codes or safety recommendations are not followed.
Description
Electric-Aire hand dryer, powered by a universal brush motor, delivering 1150 Watts of drying power. This hand dryer is
multi-voltage running on 115-208-230 Volt AC electrical supply. Operation is automatically controlled on/off, by an infrared
sensor. This appliance is intended for use in hand drying, contributing to hygienic and cost effective hand sanitation in
small business, office and light duty environments.
General Specifications
Electrical Specifications
cULus Listed E19860
(*) This hand dryer is a multi-voltage appliance that will self adjust to the available supply from 115 up to 230 VAC.
General Safety Information
DANGER
• Always disconnect the power source before servicing or installing the hand dryer.
DANGER
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is
supplied on the hand dryer’s wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
WARNING
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use wire gauge as required by local or National Electrical Code.
• Do not connect to a branch circuit with CB or fuse protection over 15 Amps. This is in compliance with The National
Electrical Code #210-20.
• All automatic model hand dryers must have a dedicated 15 Amp circuit as required by Underwriters Laboratories, Inc. (UL).
• Route all field wiring away from any moving parts within the hand dryer.
CAUTION
Improper mounting could result in personal injury or property damage.
• Follow the mounting height recommendations in Table 1.
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged
parts. If the hand dryer is damaged, promptly inform the dealer where you purchased it.