Victory VDW-65-24 User Manual

Deep well horizontal bottle coolers

Thank you for purchasing a Victory Refrigeration Deep

Well Horizontal Bottle Cooler! This unit has passed our

strict Quality Control Inspection and meets the high

standards set by Victory Refrigeration. You have made a

quality investment that with proper maintenance will give

you years of service.

Please read the following installation and maintenance

instructions before installing or using your unit. If you have

any questions, please call our Customer Service

Department at (856) 428- 4200. The Bottle Cooler is to be

used only for the storage of “non-potentially hazardous

bottled and canned beverages” !

Receiving Shipment

All units are performance tested and thoroughly inspected

prior to shipment. Upon receipt, examine the exterior of

the shipment packaging for any signs of rough handling. If

the cabinet is damaged, it should be noted on the delivery

slip or bill of lading and signed. A claim must be filed

immediately against the carrier indicating the extent and

estimated cost of damage incurred.

Locating Your New Cooler

Consider the following when selecting a cooler location:

1. Clearance - Coolers are to have a minimum clearance

space of 2”(inches) from walls and/or low ceilings.

2. Leveling - Coolers must be leveled when installed.

Although the cooler is plumbing free, failure to level

your cooler may result in condensate water not draining

appropriately.

3. Floor Load - The floor on which the cooler will rest

must be free of vibration and suitably strong enough to

support the combined weights of the cabinet plus the

maximum product load.

4. Ventilation - The air cooled, self-contained refrigeration

system requires a sufficient amount of cool, clean air.

Avoid placing the cooler near heat generating

equipment such as ovens, ranges, heaters, fryers,

steam kettles, etc., and out of direct sunlight. Avoid

locating the self-contained cooler in an unheated room,

or where the room temperature may be below 65

°F.

Electric Supply

The electrical supply should always be performed by a

qualified electrician in accordance with local electrical

codes. A properly wired cooler will assure

proper operation. Electrical supply

requirements are on the cabinet

serial/data plate located on the upper left

wall inside the cabinet. It is recommended

that a direct, properly protected line of

the proper size wire be installed from the

main supply to your cooler. All coolers

electrical systems are internally grounded.

Cleaning

Prior to setting up and operating your

new cooler, it is advisable that the

interior be washed thoroughly with a

mild, non-abrasive detergent and a

chlorine free water solution. Rinse with

clear water and a sanitizing solution.

Dry with a soft absorbent towel.

Coolers with the vinyl-coated and stainless steel exterior

require only mild soap and water to maintain the finish.

Caution: Before cleaning, servicing or removing

dividers, unplug the cooler to disconnect power!

Use non-abrasive cleaners that do

not contain chlorine and a soft cloth

or sponge. Do not use steel wool,

scrapers, wire brushes or other harsh

items to clean your cooler. Following

are some examples.

●

Baking Soda - Used for die-hard type stains. Mix in

one tablespoon of baking soda per one pint of water for