Victory VUR6-18BT - Manual (Page 5)

Cabinet Cleaning
Prior to placing your new Salad/Sandwich refrigerator and all shelves, pan dividers and food storage pans into
operation, it is advisable that the interior be washed thoroughly with a mild detergent and water solution. Rinse with clear
water and a sanitizing solution. Allow cabinet to air dry.
Installing Shelves
All cabinets with shelves are supplied with pilasters and shelf clip supports. Shelves are easily installed by inserting the
shelf support clips into the pilasters so they fit tightly. Align the shelf so the smaller fill wires run from front to rear and rest
the shelf on the clips.
Electric Supply
Wiring should be done by a qualified electrician in accordance with local electrical codes. A separate ground wire must
be supplied for all installations. A properly wired refrigerator will assure proper operation. Electrical supply requirements
are on the cabinet serial/data plate located on the upper left interior tank wall inside the cabinet. It is recommended that a
direct, properly protected line of the proper size wire be installed from the main supply to your refrigerator. To assure
that the correct voltage is being supplied, while the refrigerator is in operation take a voltage reading at the compressor-
motor electrical connections, or as close to the compressor-motor as possible.
All refrigerator electrical systems are internally grounded.
Temperature Control
Temperature control should be set to maintain a temperature of 36 °F (2.2°C) to 38°F (3.3°C) for refrigerators.
Installing Replacement Door Gasket (if required)
“Door Gasket & Retainer Strip”
Installation Checklist
After the cabinet has been installed, leveled and cleaned as described, refer to the following checklist prior to start-up.
Check for proper electrical hook-up.
Check exposed refrigeration line connections for leaks. Make sure refrigeration lines are not dented, kinked or rubbing.
Check condenser fan for freedom to rotate without striking any stationary members.
Check that cabinet is level.
Product Load
After the refrigerator has been started and reaches the proper storage temperatures, food may be loaded. For optimum
energy efficiency, we recommend allowing a 1-1/2” clearance between the interior cabinet wall and product load.
2
Removing
Beginning at one corner, pry gasket loose from the retaining strip. Peel remainder
of gasket from the door and discard.
Replacing
Before replacing, be sure the gasket and door are at room temperature. (If
necessary, soak the gasket in warmwater to make it more pliable.) Align new
gasket frame on the door retainer strip. Starting at one corner, press each corner
of the gasket into the retainer strip. Once started, the gasket can be easily inserted
around the entire perimeter of the door by simply press rolling into place.