PSA LIFPE9/1 - Manual (Page 2)

TAMPER PROTECTION FEATURE
To make the smoke alarm tamper
protected, a tamper resistant means has
been provided. To utilise this feature break
off one of the tamper protection pins from
the mounting plate and insert the pin in the
hole on the side of the mounting bracket.
Using this feature will help deter children
and others from removing the smoke alarm
from the mounting plate.
The tamper protection pin will have to be
removed in order to replace the battery.
Using a tool (small screwdriver) lever the
pin away from the mounting plate and rotate
the smoke alarm to release it from the
mounting plate.
OPERATING YOUR SMOKE ALARM
Once the smoke alarm has been installed a
small red indicator light (LED), positioned
under the test button, will flash
approximately every 30 seconds, in normal
operation. If smoke is detected the unit will
emit a loud pulsating alarm until the air is
cleared. The red LED will flash indicating an
alarm condition.
ALARM SILENCER (MUTE) FEATURE
The smoke alarm model LIFPE9M have the
capability of temporarily disabling the alarm
circuit for approximately 10 minutes. This
feature is to be used only when a known alarm
condition, such as smoke from cooking,
activates the smoke alarm.
The smoke alarm is desensitized marginally
by pushing the MUTE/TEST button on the
smoke alarm. The alarm will silence
immediately and the red LED will flash
approximately every 8 seconds for about
10 minutes to indicate the alarm is in the
mute position
.
The smoke alarm will automatically reset
after approximately 10 minutes. If after this
period particles of combustion are still
present, the alarm will sound again. The
mute button can be used repeatedly until
all the air has been cleared of the cause of
the alarm.
NOTE: Dense smoke will override the
alarm silencer (MUTE) feature and
sound a continuous alarm.
TESTING YOUR SMOKE ALARM
It is recommended that you test your smoke
alarm once a week to ensure the smoke
alarm is working correctly. Push and hold
the test button for approximately 3 seconds.
A loud pulsating alarm should sound to
indicate the correct function. During the
alarm the indicator light will flash quickly.
MAINTAINING YOUR SMOKE ALARM
The smoke alarm is virtually maintenance
free. However, periodically, clean your
smoke alarm to prevent dust build up. This
can be done by using a vacuum cleaner
with the brush attachment. Gently clean the
front grill section and sides.
BATTERY REPLACEMENT
The smoke alarm is powered by one 9V
battery. The battery should provide
operation for at least one year under normal
operating conditions. If the smoke alarm
emits a short “beep” once every 30 seconds
the battery is at the end of its life and should
be replaced immediately. The low battery
“beep” will continue for at least 7 days or
until the battery is replaced. Use only those
9V batteries listed in the specification
section of this manual.
These batteries can be purchased at
your local retail outlet or supermarket.
Please use only specified batteries. Use
of different battery may have detrimental
effect on operation.
It is recommend that smoke alarms to be
replaced every 10 years.
MISSING BATTERY INDICATOR
This smoke alarm will not operate without a
fitted battery. When the battery is removed
from the smoke alarm, a spring lever will
rise in the battery compartment which will
prevent the unit from being locked in place
on the mounting plate.
IMPORTANT SAFEGUARDS
Installation of your smoke alarm is only one
step in your safety plan. Other important
steps should be taken to further improve
your safety:-
• Install the smoke alarm properly,
following this instruction leaflet.
• Test your smoke alarm weekly.
• Replace the battery immediately once
depleted.
• Do not smoke in bed.
• Keep matches & lighters away from
children.
• Store flammable materials in a proper
manner and never use them near naked
flames or sparks.
• Maintain emergency equipment such as
Fire Extinguishers, Fire Blankets, Escape
Ladders etc and ensure all occupants
know how to use them correctly.
• Plan an escape route/s from your building
in advance and ensure all occupants are
aware of them. Re-enforce this
awareness periodically throughout the
year.
• Make sure escape routes remain free of
any obstructions.
ALTHOUGH A SMOKE ALARM CAN HELP
SAVE LIVES BY PROVIDING AN EARLY
WARNING OF A FIRE, IT IS NOT A
SUBSTITUTE FOR PROPERTY
INSURANCE OR LIFE INSURANCE OF
ANY KIND. APPROPRIATE INSURANCE
COVER IS THE RESPONSIBILITY OF THE
HOME OWNER.
THIS PRODUCT IS A SEALED UNIT AND
CANNOT BE REPAIRED. IF THE UNIT IS
TAMPERED WITH IT WILL INVALIDATE
THE WARRANTY. IF THE UNIT IS FAULTY
PLEASE RETURN IT WITH YOUR PROOF
OF PURCHASE TO YOUR PLACE OF
PURCHASE.
SMOKE ALARM WARRANTY
PSA Products Pty Ltd warrants to the
original purchaser each new smoke alarm
to be free from defects in materials and
workmanship, under normal use and
services, for a period of two (2) years from
the date of purchase. The company will not
be obligated to repair or replace parts which
are found to be in need of repair or replace
parts because of misuse, damage or
alterations incurred after date of purchase.
PSA Products Pty Ltd agrees to repair or
replace, at its option, any defective smoke
alarm provided that it is returned with proof
of purchase and return postage prepaid to
PSA Products Pty Ltd. To the extent
permitted by law, the liability of PSA
Products Pty Ltd arising from the sale of this
smoke alarm or under the terms of this
limited warranty, shall not in any case
exceed the cost of a replacement smoke
alarm and subject to this clause, in no case
shall PSA Products Pty Ltd be liable for
consequential loss or damages resulting
from the failure of the smoke alarm or
breach of this, or any other warranty,
express or implied, loss or damage caused
by failure to abide by the instructions
supplied in this user manual. This warranty
is an addition to and does not exclude the
rights of consumers under the Australian
Trade Practices Act 1974, or any other law
which may not be excluded.
Register this product for warranty on-line;
www.psaproducts.com.au
It is recommended that smoke alarms to be
replaced every 10 years.
Another Quality Product by:
PSA Products Pty Ltd
17 Millicent Street
Burwood
Victoria 3125
Ph: (03) 9888 9889
Fax: (03) 9888 9993
E-mail: [email protected]
Website: www.psaproducts.com.au
WARNING: DESIGN PATENT
SMOKE ALARM MODELS LIFPE9/1,
LIFPE9M ARE PRODUCTS DESIGNED BY
PSA PRODUCTS PTY LTD. THEY MUST
NOT BE REPRODUCED OR COPIED.
LEGAL ACTION WILL BE TAKEN
AGAINST ANY INFRINGEMENT.