PSA LIFRK10A/9 User Manual
Page 2
2
March 09
Figure 2: Connections using the 4
th
Terminal
and using 24Vdc input
Connecting the 24V DC input from the Fire Indicator
Panel permits the smoke alarm to be activated externally
using the 4
th
terminal. The Smoke Alarm can be used as
part of an early warning system. The activation of the Fire
Indicator Panel will send an alarm signal via its auxiliary
output to the RK10A/9. The 24 Volts DC signal will be
relayed to the RK10A/9 relay which will activate the 24
volt dc relay and close the contacts between 9 volt and
switch-line connections.
This will activate all smoke alarms in all apartments, thus
acting as an early warming to all occupants.
TECHNICAL NOTE
The wiring connecting the module with the external device
is not supervised. Be sure to test the operation of all the
devices controlling the module or controlled by the module.
Devices controlled by the module can be tested by pushing
the test button on the alarms and verifying that the
controlled device responds in the desired manner. Devices
controlling the module can be tested by activating the
device and verifying that all of the interconnected alarms
enter alarm.
WARRANTY.
The liability of PSA Products Pty Ltd arising from the sale of
this Isolation Relay or under the terms of this limited warranty
shall not exceed the cost of replacement of the Isolation Relay
and in no case shall PSA Products Pty Ltd be liable for
consequential loss or damages resulting from the failure of the
Isolation Relay or breach of this or any other warranty,
express or implied, loss or damages caused by failure to abide
by the instructions supplied in this leaflet.
This warranty shall not apply to the Isolation Relay if it
has been damaged, modified, abused or altered after the
date of purchase or if it fails to operate due to improper
installation or misuse.
Another Quality Product by:
PSA Products Pty Ltd
17 Millicent Street, Burwood
Victoria 3125 Australia
Telephone: (03) 9888 9889
Facsimile: (03) 9888 9993
e-mail: [email protected]
web-site: www.psaproducts.com.au
1201-7210-03