Poweramp POWERSTOP MAN 11.1996 - Manual (Page 11)

OPERATION WITH MANUAL LIGHTS
1. Switch the inside control box light control switch to the released position. Verify
that the green light has illuminated.
2. Verify that the trailer is parked tight against both bumpers.
3. Insert one end of the operating bar under the release lever on the left hand side of
the restraint.
4. Lift up on the operating bar, causing the release lever to rotate, thus activating the
restraint. With the restraint activated, the restraint arm will move vertically.
5. Visually inspect and confirm that the truck restraint arm has travelled vertically
and has engaged the horizontal member of the ICC bar. Visually verify that the
outside light has switched to red and that the activated light inside is illuminated.
6. Return operating bar to its storage bracket.
7. Activate dock leveler and proceed to load/unload.
8. When loading/unloading of truck is completed, return the dock leveler to the
stored position.
9. Insert operating bar into the top of the slide track on the truck restraint.
10. Push the restraint arm down until the release lever locks on the carriage body.
11. Switch the inside control box light control switch to the stored position. Verify
that the red light has illuminated.
OPERATION WITHOUT LIGHTS
1. Verify that the trailer is parked tight against both bumpers.
2. Insert one end of the operating bar under the release lever on the left hand side of
the restraint.
3. Lift up on the operating bar, causing the release lever to rotate, thus activating the
restraint. With the restraint activated, the restraint arm will move vertically.
4. Visually inspect and confirm that the truck restraint arm has travelled vertically
and has engaged the horizontal member of the ICC bar.
5. Return operating bar to its storage bracket.
6. Activate dock leveler and proceed to load/unload.
7. When loading/unloading of truck is completed, return the dock leveler to the
stored position.
8. Insert operating bar into the top of the slide track on the truck restraint.
9. Push the restraint arm down until the release lever locks on the carriage body.
10. Return the operating bar to the storage rack.
Operation
9