Warning, Helpful tip – Poulan Pro BVM200C User Manual

Page 8

-- 8 --

Conserve water by using power blowers

instead of hoses for many lawn and garden

applications, including areas such as gutters,

screens, patios, grills, porches, and gardens.

Watch out for children, pets, open windows,

or freshly washed cars. Blow debris away

safely.

Use the full blower nozzle extension so the

air stream can work close to the ground.

After using blowers and other equipment,

CLEAN UP! Dispose of debris in trash re-

ceptacles.

OPERATING POSITION

WARNING:

While vacuuming or

blowing debris, hold the unit with the muffler

side facing away from your body and clothes

(see following illustration).

Blower

Vacuum

BEFORE STARTING ENGINE

WARNING:

Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING:

Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2--cycle synthetic oil into

one gallon of fresh gas.

This engine is certified to operate on unleaded

gasoline. Before operation, gasoline must be

mixed with a good quality synthetic 2-cycle

air-cooled engine oil designed to be mixed at a

ratio of 40:1. Poulan PRO brand synthetic oil is

recommended. Mix gasoline and oil at a ratio of

40:1. A 40:1 ratio is obtained by mixing 3.2 fluid

ounces (95 ml) of oil with 1 gallon (4 liters) of

unleaded gasoline. DO NOT USE automotive

oil or marine oil. These oils will cause engine

damage. When mixing fuel, follow instructions

printed on container. Once oil is added to

gasoline, shake container momentarily to

assure that the fuel is thoroughly mixed. Always

read and follow the safety rules relating to fuel

before fueling your unit.

CAUTION:

Never use straight gasoline in

your unit. This will cause permanent engine

damage and void the limited warranty.

FUEL REQUIREMENTS

This engine requires the use of minimum 87

octane [R+M]/2 clean gasoline.

IMPORTANT

Use of alcohol blended fuels (called gasohol or

using ethanol or methanol) can cause major

engine performance and durability problems.

WARNING:

Alternative fuels (not gas-

oline) such as E--15 (15% alcohol), E--20 (20%

alcohol), E--85 (85% alcohol) are NOT classified

as gasoline and are NOT approved for use in

2--stroke gasoline engines. Use of alternative

fuels will cause problems such as: improper

clutch engagements, overheating, vapor lock,

power loss, lubrication deficiency, deterioration

of fuel lines, gaskets and internal carburetor

components, etc. Alternative fuels cause high

moisture absorption into the fuel/oil mixture

leading to oil and fuel separation.

HOW TO STOP YOUR ENGINE

Release the throttle trigger.

Push and hold the STOP switch in the

STOP position until the engine stops.

HOW TO START YOUR ENGINE

WARNING:

You MUST make sure

the tubes are secure before using the unit.

Fuel engine. Move at least 10 feet (3 me-

ters) away from the fueling site.

Hold the unit in the starting position as

shown. Make sure the blower end is di-

rected away from people, animals, glass,

and solid objects.

Blower

Vacuum

STARTING POSITION

WARNING:

When starting engine,

hold the unit as illustrated. Do not set unit on any

surface except a clean, hard area when starting

engine or while engine is running. Debris such

as gravel, sand, dust, grass, etc. could be

picked up by the air intake and thrown out

through the discharge opening, damaging the

unit or property, or causing serious injury to by-

standers or the operator.