Poulan Pro 961240002 LAWN MOWER - Manual (Page 14)

14
Recoil
starter
handle
Operator
presence
control bar
MODELS WITH RECOIL START ER
• Pull starter handle quickly. Do not allow
starter rope to snap back.
BEFORE STARTING EN GINE
Read the engine manual packed with your
mower.
FILL ENGINE WITH OIL
Your lawn mower is shipped without oil in
the engine.
• Be sure mower is level and area around
oil fi ll is clean.
• Remove engine oil fi ller plug (oil fi ll cap/
dipstick on models so equipped).
• Slowly add oil. For type and grade of
oil to use, see “ENGINE” in the Mainte-
nance section of this manual.
• Fill to the top of slot in fi ller hole (to
“FULL” line on dipstick on models so
equipped). Do not overfi ll.
• Replace plug (oil fi ll cap/dipstick on
models so equipped) and tighten.
• Check oil level before each use. Add oil
as needed.
• To change oil, see Maintenance section
of this manual.
FILL GASOLINE TANK
• Fill gasoline tank with fresh, clean,
unleaded gaso line. DO NOT USE PRE-
MIUM GASOLINE. BE CARE FUL NOT
TO OVERFILL TANK.
WARNING: Al co hol blended fuels (called
gaso hol or using ethanol or metha nol) can
at tract mois ture which leads to sepa ra tion
and for ma tion of acids during storage. Acidic
gas can damage the fuel system of an en gine
while in stor age. To avoid engine prob lems,
the fuel system should be emptied before
stor age of 30 days or longer. Drain the fuel
tank, start the engine and let it run until fuel
lines and car bu re tor are empty. Use fresh
fuel next season. See Stor age In struc tions
for ad di tion al in for ma tion. Never use en gine
or car bu re tor clean er prod ucts in fuel tank or
per ma nent dam age may occur.
TO START ENGINE
CAUTION: The mow er blade rotates
whenever the engine is running.
• Move engine speed control to FAST
position (or to CHOKE/START position
on models equipped with choke feature).
• If your mower has a primer, to start a
cold engine, push primer as many times
as in struct ed in the engine manual
packed with your mower. Use a fi rm
push. This step is not usually nec es sary
when start ing an engine which has
already run for a few minutes.
• Hold operator presence control bar
down against han dle.
MODELS WITH ELECTRIC START ER
• Push the engine start button (or turn the
key on models so equipped).
IMPORTANT: Do not crank engine more
than fi ve continous seconds each time you
try to start. Wait 5 to 10 seconds between
each attempt.
ALL MODELS
• For engines equipped with choke, slowly
move engine speed control lever to
FAST after engine starts.
TO STOP ENGINE
• To STOP engine, release operator pres-
ence control bar.
NOTE: For engines with a primer, it may
be nec es sary to repeat priming steps
in cooler weather. In warmer weath er,
overpriming may cause fl ood ing and
en gine will not start. If you do fl ood
engine, wait a few minutes before
attempting to start and DO NOT repeat
priming steps.
15
MAX 1/3
MOWING TIPS
CAUTION: Do not use de-thatcher
blade attachments on your mower. Such
attachments are hazardous, will damage
your mower and could void your warranty.
• For most cutting conditions and bet ter
bagging per form ance, the engine speed
should be set in the FAST po si tion.
• Under certain conditions, such as when
mowing very tall grass, raise the mower
height on the fi rst cut to reduce pushing
effort, to avoid over heat ing the engine,
and to avoid leaving clumps of grass
clippings. Make the second cut to the
desired height.
• For extremely heavy cutting, reduce the
width of cut.
• For side discharge lawn mowers, cut in
a coun ter clock wise di rec tion, start ing at
the outside of the area to be cut, in order
to spread grass clip pings more evenly
and to put less load on the engine. To
keep clip pings off of walkways, fl ower
beds, etc., make the fi rst cuts in a clock-
wise direction.
• When using a rear discharge lawn
mower in moist, heavy grass, clumps
of cut grass may not enter the grass
catcher. Reduce ground speed (push ing
speed) and/or run the lawn mower over
the area a second time.
• If a trail of grass clipping is left on the
right side of a rear discharge lawn mow-
er, mow in a clockwise direction with a
small overlap to collect the clippings on
the next pass.
FOR MULCHING MOWERS ONLY
- MULCHING MOWING TIPS
IMPORTANT: For best performance, keep
mower housing free of built-up grass and
trash. See "CLEANING" in the Mainte-
nance section of this manual.
• The special mulching blade will recut the
grass clip pings many times and reduce
them in size so that as they fall onto the
lawn they will disperse into the grass
and not be noticed. Also, the mulched
grass will bio de grade quickly to provide
nu tri ents for the lawn. Always mulch with
your highest engine (blade) speed as
this will provide the best recutting action
of the blades.
• Avoid cutting your lawn when it is wet.
Wet grass tends to form clumps and
in ter feres with the mulch ing action. The
best time to mow your lawn is the early
afternoon. At this time the grass has
dried, yet the newly cut area will not be
exposed to direct sunlight.
• For best results, adjust the lawn mower
cutting height so that the lawn mower
cuts off only the top one-third of the
grass blades. If the lawn is overgrown it
will be necessary to raise the height of
cut to reduce pushing effort and to keep
from over load ing the engine and leaving
clumps of mulched grass. For ex tremely
heavy grass, reduce your width of cut
by overlapping previously cut path and
mow slowly.
• Pores in cloth grass catchers can
become fi lled with dirt and dust with use
and the catcher will collect less grass.
To prevent this, regularly hose catcher
off with water and let dry before use.
• Certain types of grass and grass
con di tions may re quire that an area be
mulched a second time to com pletely
hide the clip pings. When doing a sec ond
cut, mow across (per pen dic u lar) to the
fi rst cut path.
• Change your cutting pattern from week
to week. Mow north to south one week
then change to east to west the next
week. This will help prevent matting and
graining of the lawn.