Poulan Pro 461ZX_966681802 LAWN TRACTOR - Manual (Page 18)

18
oPERaTIoN
IMPORTANT INFORMATION Do not run the starter for
more than 5 seconds each time. If the engine does not
start, wait approximately 10 seconds before retrying.
WARNING! Make sure that no one is near mower
when engaging blade switch.
Make sure the work area is free from objects that could be
thrown by the rotating blades.
WARNING! Do not drive up or down hills with slopes
greater than 10 degrees. Do not drive across slopes.
8. Press in and turn the ignition key to the start position.
9. When the engine starts, immediately release the ignition
key back to the run position. Slowly shift the throttle out of
the CHOKE position.
10. Set the engine speed with the throttle. Allow the engine to
run at a moderate speed, approximately mid throttle, for a
short time before use.
11. USE FULL THROTTLE WHEN MOWING.
Running
1. Release the park prake by pushing the top release button
in and moving the lever downward.
NOTE: The mower is equipped with an operator presence
system. When the engine is running, any attempt by the
operator to leave the seat without first setting the park
prake will shut off the engine.
2. Move the steering controls inwards, out of the neutral
position (N).
3. Push the release button on the cutting height lever and
move lever to the pin, release the button.
4. Move throttle control to full throttle.
5. Engage the mower deck by pulling up the blade switch.