beautypg.com

Assembly, See figs. 4-12), Assemble front wheel to mower (see fig. 3) – Poulan Pro PB22H54YT LAWN TRACTOR User Manual

Page 6

background image

6

ASSEMBLY

INSTALL MOWER AND DRIVE BELT

(See Figs. 4-12)

See MOWER AND DRIVE BELT ASSEMBLY Supplement
Sheet for additional guidance on this assembly.

Be sure tractor is on level surface and engage park ing
brake.
• Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. Have
a tight grip on lift lever, lower it slowly and
engage in lowest position.

• Turn steering wheel to the left as far as it will go and

position mower on right side of tractor with defl ector
shield to the right.

• Remove plastic tie securing belt, bring belt forward

and check belt for proper routing in all mower pulley
grooves.

02965

02

051

A

ASSEMBLE FRONT WHEEL TO
MOWER (See Fig. 3)

• Using shoulder bolt, washer and locknut from parts

bag, as sem ble front wheel to mower as shown. Tighten
securely.

FIG. 3

FIG. 4

FIG. 5

FIG. 2

A

NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction below to remove the
tractor from the skid.

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID (See Op-
er a tion section for location and function of
con trols)

• Raise attachment lift lever to its highest po si tion.
• Release parking brake by de press ing brake ped al.
• Place freewheel control in dis en gaged po si tion to dis-

en gage trans mis sion (See “TO TRANS PORT” in the
Op er a tion section of this manual).

• Roll tractor forward off skid.

TO DRIVE TRAC

TOR OFF SKID (See Op-

er a tion section for location and function of
con trols)

• Be sure all the above assembly steps have been com-

pleted.

• Check engine oil level and fi ll fuel tank with gasoline.
• Place freewheel control in "trans

mis sion engaged"

position (see "TO TRANSPORT" in Operation section
of this manual).

• Sit on seat in operating position, depress brake pedal

and set the parking brake.

• Raise attachment lift lever to its highest position.
• Remove key from bag and start the engine (see "TO

START" in the Operation section of this manual). After
engine has started, move throttle control to idle (slow)
position.

• Release parking brake.
• Slowly depress forward drive pedal and drive tractor

off skid.

• Apply brake to stop tractor and set park ing brake.
• Turn ignition key to "STOP" position.

Continue with the in struc tions that follow.