Bosch PHC9690 Lockenformer ProSalon G-curler - Manual (Page 15)

PHC9690 07/2011
11 en
Congratulations on purchasing this
Bosch appliance.
You have acquired a high-quality prod-
uct that will bring you a lot of enjoyment.
Parts and operating
controls
1 on/off switch
2 Temperature selector Ц / Ь
(min 120 °C - max 200 °C)
3 Display
4 Handle
5 Heating element
6 Threading aid
7 Cable strap
8 Storage bag (heat-resistant)
Operation
● Plug in the appliance and place on the
heat-resistant storage bag.
● To turn the appliance on, press and hold
the power switch 1 for approximately two
seconds. The preset temperature 140
(degrees Celsius) blinks on the display 3.
● The desired temperature can now be set
using the temperature selector 2 at inter-
vals of 10 between 120 °C and 200 °C:
– up to 140 °C for ine, straight hair
– approx. 180 °C for normal, wavy hair
– from 180 °C for strong, curly hair.
Tip: Reduce the temperature for dam-
aged hair (the ideal temperature is ap-
prox. 140 °C) to protect it.
● The appliance heats up. Once the se-
lected temperature has been reached, the
display shows OK and the temperature
stops blinking.
Note: To turn the appliance off, press and
hold the power switch 1 on/off for approxi-
mately two seconds.
Use
Risk of burns!
Never allow appliance to come into
contact with skin (scalp or ears).
● Only use the appliance on dry hair.
Note: Extensive use can damage the hair.
Styling your hair
This wave iron was designed for creating
waves in medium to long hair.
Proceed as follows:
● Comb the hair and divide it into even, lat
strands about 2 to 3 cm wide.
● Make sure that adjacent strands are
slightly offset.
● Attach the upper strands to the top of the
head with hair clips; start the styling proc-
ess with the lower strands (Fig. 1).
● Insert a strand of hair at the lower third
into the gap in the heating element. Use
the longer arm of the heating element as
a threading aid (Fig. 2).
● Hold the appliance in a level position and
lock the tip of the strand into position by
turning it once or twice; hold the hair ends
with your ingers (Figures 3 and 4).
● Roll up the strand along the heating ele-
ment by rotating it (Fig. 4).
● Heat the rolled-up strand for approxi-
mately six seconds (Fig. 5).
● Unroll the curl by half a rotation and pull
the appliance out sideways. Hold the curl
in place or ix it in place with a hair clip
(Figures 6, 7 and 8).
● Let the curl cool down to stabilize its
shape.
● Treat all strands; when you are done,
style the hair with a large-toothed comb
or with your ingers.
PHC9690_110712.indd 11 12.07.2011 16:41:38