Ultra Start KEU-300 Series - Manual (Page 7)

System Programming
The following features are programmed using the ignition switch and the
LED/ Program Switch.
To Enter Program Mode
1) Turn the ignition key “ON/OFF”, “ON/OFF” “ON” Leaving the key in the ON
position.
2) Press and release the LED/ Valet Switch One time. The system will
respond with one park light flash and on Siren/ Horn chirp.
System Reset
1) Turn the ignition key “ON/OFF”, “ON/OFF” “ON”, press and release the
program switch. The system will respond with one park light flash and one
Siren/ Horn chirp.
2) Press and hold the program switch for 3 seconds.
*The park lights will flash and the siren will chirp 3 times to confirm reset.
Setting #1- Secure Valet Mode
Turn the ignition key “ON/OFF”, “ON/OFF” “ON”, press and release the
program switch. The LED will flash One time to confirm setting one. Hold the
program switch until the siren chirps the appropriate number of times.
1 Chirp Secure Valet 15 seconds to place the system in valet.
2 Chirps Standard Valet 5 seconds to place the system in valet
Setting #2- Auto Rearm
Turn the ignition key “ON/OFF”, “ON/OFF” “ON”, press and release the
program switch 2 times. The LED will flash twice to confirm setting two.
Hold the program switch until the siren chirps the appropriate number of
times.
1 Chirp Auto Arming Arms 30seconds after unlock is pressed
or 30 seconds after last door is closed
2 Chirps Disabled Arms with remote only
Continued on next page...
REMOTE VEHICLE SECURITY
INSTALL MANUAL
PAGE 7